Yes, I know, the picture isn’t the best but I was so excited that I wanted to take it quickly in order to take out the fabric.
I had this thing in mind for a long time and today I made it!
I basically tried to cut and engrave this piece of cotton with the laser cutter at the Sci FabLab.
The first 2 were speed 5 and power 25 and 15. With this power (15) the cut is very precise.
The last 2, on the right, are engraved with speed 150 power 20 and 15. 20 is too much, so, once I took it in my hand, it faded at first and then just deteriorated.

I’m looking forward to making new experiments!